![]() ![]() I had similar issues with my Supermicro - X9SRL-F unRaid build in a Consumer Phanteks Enthoo Pro case with a built in PWM hub fan controller. Fortunately you don't have to restart the server, power down or unplug from A/C, just reset the BMC. Smc fan control wont adjust full#If you make any Fan setting changes that would potentially fix the issue, you must restart the BMC, else the board will continually switch back to Full Speed even if the new settings are correct. You can go back and forth with the board changing the setting every few seconds only to have the board change it back to Full Speed. If you change the Fan Speed via command utility of IPMIView and the board believes something is amiss, it will change the Fan Speed back to Full Speed. If a temp issue or fan issue is detected by the board, it will switch to Full Speed. ![]() ![]() Check to see that the board isn't changing the Fan Mode to Full Speed. Click to expand.You probably don't need to set the limits back to their old values, as changing them requires some effort (see below). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |